Filter
Top Products
DescriptionName
The name of the policy.
This name can be between 1 and 16 alphanumeric characters. You
cannot use spaces or any special characters other than - (hyphen), _
(underscore), : (colon), and . (period), and you cannot change this name
after the object has been saved.
Name field
The number of seconds to wait until Cisco UCS assumes that the initial
login has failed and the iSCSI adapter is unavailable.
Enter an integer between 0 and 255. If you enter 0, Cisco UCS uses the
value set in the adapter firmware (default: 15 seconds).
Connection Timeout field
The number of times to retry the connection in case of a failure during
iSCSI LUN discovery.
Enter an integer between 0 and 60. If you enter 0, Cisco UCS uses the
value set in the adapter firmware (default: 15 seconds).
LUN Busy Retry Count field
The number of seconds to wait before the initiator assumes that the
DHCP server is unavailable.
Enter an integer between 60 and 300 (default: 60 seconds).
DHCP Timeout field
Check this box if you want to use a TCP Timestamp. With this setting,
transmitted packets are given a time stamp of when the packet was sent
so that the packet's round-trip time can be calculated, when needed.
This option only applies to servers with the Cisco UCS NIC
M51KR-B adapter.
Note
Enable TCP Timestamp check
box
Check this box to enable HBA mode.
This option should only be enabled for servers with the
Cisco UCS NIC M51KR-B adapter running the Windows
operating system.
Important
HBA Mode check box
Check this box to boot from the iSCSI target.
This option only applies to servers with the Cisco UCS NIC
M51KR-B adapter. It should be disabled until you have
installed an operating system on the server.
Note
Boot to Target check box
Step 6
Click OK.
What to Do Next
Include the adapter policy in a service profile and/or template.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
448 OL-25712-04
iSCSI Boot