Filter
Top Products
Step 5
Click OK.
What to Do Next
• Add traffic sources to the traffic monitoring session.
• Activate the traffic monitoring session.
Adding Traffic Sources to a Monitoring Session
You can choose multiple sources from more than one source type to be monitored by a traffic monitoring
session. The available sources depend on the components configured in the Cisco UCS domain.
This procedure describes how to add sources for Ethernet traffic monitoring sessions. To add sources for
a Fibre Channel monitoring session, select the SAN tab instead of the LAN tab in Step 2.
Note
Before You Begin
A traffic monitoring session must be created.
Procedure
Step 1
In the Navigation pane, click the LAN tab.
Step 2
On the LAN tab, expand LAN > Traffic Monitoring Sessions > Fabric_Interconnect_Name.
Step 3
Expand Fabric_Interconnect_Name and click the monitor session that you want to configure.
Step 4
In the Work pane, click the General tab.
Step 5
In the Sources area, expand the section for the type of traffic source that you want to add.
Step 6
To see the components that are available for monitoring, click the + button in the right-hand edge of the table
to open the Create Monitoring Session Source dialog box.
Step 7
Select a source component and click OK.
You can repeat the preceding three steps as needed to add multiple sources from multiple source types.
Step 8
Click Save Changes.
What to Do Next
Activate the traffic monitoring session. If the session is already activated, traffic will be forwarded to the
monitoring destination when you add a source.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
OL-25712-04 645
Adding Traffic Sources to a Monitoring Session