Filter
Top Products
Step 9
Click OK.
FCoE and Fibre Channel Storage Ports
Configuring an FCoE Storage Port
You can configure FCoE storage ports on either the fixed module or an expansion module.
This task describes only one method of configuring FCoE storage ports. You can also configure FCoE storage
ports from the General tab for the port.
Before You Begin
The Fibre Channel switching mode must be set to Switching for these ports to be valid. The storage ports
cannot function in end-host mode.
Procedure
Step 1
In the Navigation pane, click the Equipment tab.
Step 2
On the Equipment tab, expand Equipment > Fabric Interconnects > Fabric_Interconnect_Name.
Step 3
Depending upon the location of the ports you want to configure, expand one of the following:
• Fixed Module
• Expansion Module
Step 4
Click one or more of the ports under the Unconfigured Ethernet Ports node.
If you want to reconfigure an uplink Ethernet port, server port, or appliance port, expand the appropriate node.
Step 5
Right-click the selected port or ports and choose Configure as FCoE Storage Port.
Step 6
If the Cisco UCS Manager GUI displays a confirmation dialog box, click Yes.
Step 7
Click OK.
The port or ports are configured as FCoE storage ports, removed from the list of unconfigured ports, and
added to the FCoE Storage Ports node.
Configuring a Fibre Channel Storage Port
This task describes only one method of configuring FC storage ports. You can also configure FC storage ports
from the General tab for the port.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
94 OL-25712-04
FCoE and Fibre Channel Storage Ports