Filter
Top Products
Packages
This view provides you with a read-only representation of the firmware bundles that have been
downloaded onto the fabric interconnect. This view is sorted by image, not by the contents of the image.
For packages, you can use this view to see which component images are in each downloaded firmware
bundle.
Images
The images view lists the component images available on the system. You cannot use this view to see
complete firmware bundles or to group the images by bundle. The information available about each
component image includes the name of the component, the image size, the image version, and the
vendor and model of the component.
You can use this view to identify the firmware updates available for each component. You can also use
this view to delete obsolete and unneeded images. Cisco UCS Manager deletes a package after all
images in the package have been deleted.
Cisco UCS Manager stores the images in bootflash on the fabric interconnect. In a cluster system, space
usage in bootflash on both fabric interconnects is the same, because all images are synchronized between
them. If Cisco UCS Manager reports that the bootflash is out of space, delete obsolete images to free up
space.
Tip
Firmware Versions
The firmware version terminology used depends upon the type of endpoint, as follows:
Firmware Versions in CIMC, I/O Modules, and Adapters
Each CIMC, I/O module, and adapter has two slots for firmware in flash. Each slot holds a version of firmware.
One slot is active and the other is the backup slot. A component boots from whichever slot is designated as
active.
The following firmware version terminology is used in Cisco UCS Manager:
Running Version
The running version is the firmware that is active and in use by the endpoint.
Startup Version
The startup version is the firmware that will be used when the endpoint next boots up. Cisco UCS
Manager uses the activate operation to change the startup version.
Backup Version
The backup version is the firmware in the other slot and is not in use by the endpoint. This version can
be firmware that you have updated to the endpoint but have not yet activated, or it can be an older
firmware version that was replacedby a recentlyactivated version.Cisco UCS Manageruses theupdate
operation to replace the image in the backup slot.
If the endpoint cannot boot from the startup version, it boots from the backup version.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
186 OL-25712-04
Firmware Versions