Filter
Top Products
Some of the configuration that you can do in the LAN Uplinks Manager can also be done in nodes on other
tabs, such as the Equipment tab or the LAN tab.
Launching the LAN Uplinks Manager
Procedure
Step 1
In the Navigation pane, click the LAN tab.
Step 2
On the LAN tab, click the LAN node.
Step 3
In the Work pane, click the LAN Uplinks Manager link on the LAN Uplinks tab.
The LAN Uplinks Manager opens in a separate window.
Changing the Ethernet Switching Mode with the LAN Uplinks Manager
When you change the Ethernet switching mode, Cisco UCS Manager logs you out and restarts the fabric
interconnect. For a cluster configuration, Cisco UCS Manager restarts both fabric interconnects sequentially.
The second fabric interconnect can take several minutes to complete the change in Ethernet switching
mode and become system ready. The configuration is retained.
Important
Procedure
Step 1
In the LAN Uplinks Manager, click the LAN Uplinks tab.
Step 2
In the Uplink Mode area, click one of the following buttons:
• Set Ethernet Switching Mode
• Set Ethernet End-Host Mode
The button for the current switching mode is dimmed.
Step 3
In the dialog box, click Yes.
Cisco UCS Manager restarts the fabric interconnect, logs you out, and disconnects Cisco UCS Manager GUI.
Configuring a Port with the LAN Uplinks Manager
You can only configure server ports on the fixed port module. Expansion modules do not include server ports.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
264 OL-25712-04
Launching the LAN Uplinks Manager