Cisco Systems OL-25712-04 Security Camera User Manual


 
zoning option in Cisco UCS Manager is whether the default zone in a VSAN (nodes not assigned to any zone)
permits or denies access among its members.
When default zoning is enabled, all traffic is permitted among members of the default zone.
When default zoning is disabled, all traffic is denied among members of the default zone.
Default zoning is applied on a per-VSAN basis. You cannot enable default zoning at the fabric level.
Default zoned configurations are not recommended for production deployments, which must always use
direct connect Fibre Channel topologies with upstream MDS or Nexus 5000 switches.
Note
Enabling Default Zoning
Procedure
Step 1
In the Navigation pane, click the SAN tab.
Step 2
In the SAN tab, click the SAN node.
Step 3
In the Work pane, click the VSANs tab.
Step 4
Click one of the following subtabs, depending upon the type of VSAN for which you want to enable default
zoning:
DescriptionSubtab
Displays all VSANs in the Cisco UCS domain.
All
Displays the VSANs that are accessible to both fabric interconnects.
Dual Mode
Displays the VSANs that are accessible to only fabric interconnect A.
Switch A
Displays the VSANs that are accessible to only fabric interconnect B.
Switch B
Step 5
In the table, double-click the VSAN.
Cisco UCS Manager GUI displays the General tab for the VSAN.
Step 6
In the Actions area, click Enable Default Zoning.
Step 7
If the Cisco UCS Manager GUI displays a confirmation dialog box, click Yes.
Cisco UCS Manager GUI Configuration Guide, Release 2.0
96 OL-25712-04
FCoE and Fibre Channel Storage Ports