Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
991Trunk Group
17
NOTE:
In a DCS network, DCS features that use the remote-tgs button (on phones
at a remote switch) do not work when the incoming trunk group at your
switch deletes or inserts digits on incoming calls. The remote-tgs button on a
remote switch, for example, tries to dial a TAC on your switch. If your
switch adds or deletes digits, it defeats this operation. If you need to
manipulate digits in a DCS network (for example, to insert an AAR feature
access code), do it on the outgoing side based on the routing pattern.
Digits
This field is used with the Digit Treatment field, and its meaning depends on the
entry in that field. If the Digit Treatment field is
absorption, this field specifies
how many digits are deleted. If the Digit Treatment field is
insertion, this field
identifies the specific digits that are added.
Expected Digits
NOTE:
Set this field to blank if the Digit Treatment field is set to insert and
the Digits field contains a feature access code (for example, AAR or
ARS) followed by digits. In this case, the number of digits expected
are set on the AAR and ARS Digit Analysis Table and AAR and ARS
Digit Conversion Table.
Valid entries Usage
1 to 5 Enter the number of digits to be deleted (absorbed).
Up to 4 digits,
including * and
#
Enter the actual digits to be added (inserted).
blank This field can be blank only if the Digit Treatment field is
blank.
Valid entries Usage
1
to 18 Enter the number of digits that the far-end switch sends for an
incoming connection. If your switch is absorbing digits on this
trunk group, the entry in this field must be larger than the entry
in the Digits field.
blank If you leave this field blank, you cannot administer digit
absorption.