Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Routing outgoing calls
192Defining ARS Partitions
8
2. Record the route pattern for the selected dialed string.
In our example, the route pattern for 1800 is p1. This indicates that the
system uses the Partition Routing Table to determine which route pattern to
use for each partition.
NOTE:
If there was a number (with no p) under Route Pattern on the Route
Chosen Report, then all partitions use the same route pattern. You
need to use the Partition Routing Table only if you want to use
different route patterns for different partition groups.
3. Press
CANCEL to return to the command prompt.
4. Type
change partition-route-table index 1 and press RETURN.
The Partition Route Table screen appears. In our example, partition group 1
can make 1800 calls and these calls use route pattern 30.
5. In the PGN2 column that corresponds to Route Index 1, type
30 and press
ENTER.
This tells the system to use route pattern 30 for partition group 2 and allow
partition group 2 members to make calls to 1800 numbers.
ARS ROUTE CHOSEN REPORT
Location : 1 Partitioned Group Number: 1
Dialed Total Route Call Node Location
String Min Max Pattern Type Number
1800___________________ 11 11 p1___ fnpa _____ all
Partition Routing Table
Routing Patterns
Route
Index PGN 1 PGN 2 PGN 3 PGN 4 PGN 5 PGN 6 PGN 7 PGN 8
----- ----- ----- ----- ----- ----- ----- ----- -----
1 __30 ____ ____ ____ ____ ____ ____ ____
2 ____ ____ ____ ____ ____ ____ ____ ____
3 ____ ____ ____ ____ ____ ____ ____ ____
4 ____ ____ ____ ____ ____ ____ ____ ____
5 ____ ____ ____ ____ ____ ____ ____ ____
6 ____ ____ ____ ____ ____ ____ ____ ____
7 ____ ____ ____ ____ ____ ____ ____ ____