Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
563Data modules
17
ppp
Assigns a Point-to-Point Protocol data module. The PPP Data
Module screen assigns a synchronous TCP/IP port on the
C-Lan. These ports are tailored to provide TCP/IP connections
for use over telephone lines. Refer to DEFINITY ECS
Administration for Network Connectivity for more information
on Point-to-Point data modules.
procr-intf
Assigns a Processor Interface Data Module. The Processor
Interface data modules are the Processor Data Modules
(PDMs) that are integrated into the system’s
synchronous/asynchronous Processor Interface circuit pack
ports.
NOTE:
The Processor Interface data module is applicable only to
G3si configurations.
They are used to provide the following interfaces:
■ 3B/Call Management System (maximum of 1)
■ 3B/Message Server (maximum of 1)
■ Distributed Communications System (maximum of 8)
■ AUDIX (maximum of 1)
NOTE:
Not all maximums can be achieved at the same time
Connections for these interfaces are achieved via a digital line
port and MPDM combination, and/or in the case of DCS or
ISDN-PRI, via a DS1 interface. One direct EIA connection is
available (labeled as Processor Interface on the back of the
Control Cabinet) for simplex operation. When used, the
physical channel assignment (see below) must be “01”. Use of
the EIA connection eliminates the need for one digital line
port/MPDM combination. Refer to DEFINITY ECS
Administration for Network Connectivity for more information
on Processor Interface data modules.
system-port
Assigns a System Port Data Module.
tdm
Assigns a DTE interface for Processor/Trunk Data Modules.
Refer to the pdm entry above.
wcbri
Assigns a World Class BRI Data Module.
Valid entries Usage