Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
1004Trunk Group
17
Used for DCS
NOTE:
This field cannot be activated if the trunk group number is greater than 255
or if the Trunk Access code is more than 3-digits long.
If this field is
y, you can administer ISDN-BRI trunk groups unless the DCS
Signaling field is
d-chan. In that case, remove the BRI trunks or set the DCS
Signaling field to
bx.25 before submitting the screen.
PBX ID
This field, which appears when the Used for DCS field is
y, identifies the remote
switch in the network with which the trunk will communicate on a DCS signaling
link.
Suppress # Outpulsing
Seize When Maintenance Busy
This field only affects ports on TN760C (or later release), TN767, and TN464C
(or later release) circuit packs. It indicates whether this switch generates an
outgoing seizure when a trunk in this trunk group is maintenance busied and
whether the far-end switch is administered to do likewise. This supports the
Electronic Tandem Network Busyout feature, which is intended to prevent a
far-end switch from reporting problems with a trunk that has been removed from
service on your switch. This field’s setting does not affect the behavior of the
far-end switch; it controls the behavior of this switch and defines the expected
far-end behavior.
Valid entries Usage
y/n
Enter y if this trunk group will send and receive messages on a
DCS signaling link.
Valid entries Usage
1
to 63 Enter the ID of the switch at the other end of this trunk.
Valid entries Usage
y/n
Enter y if end-to-end signaling begins with (and includes) “#”.
The final “#” is suppressed in cases where the system would
normally outpulse it. This field should be
y when the Central
Office (for example, rotary) or any other facility treats “#” as
an error.