Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
827Multifrequency-Signaling-Related System Parameters
17
Outgoing Forward Signal Present Timer (sec)
This field appears only when the value of Outgoing Call Type is
group-ii-mfc.
Outgoing Forward Signal Absent Timer (sec)
This field appears only when the content of Outgoing Call Type is
group-ii-mfc.
Multifrequency Signaling Incoming Intercept
Treatment
Overlap Sending on Link-to-Link Tandem Calls
A DEFINITY ECS with this field set to
y, when tandeming calls between switches
will send ANI for PBX to the terminating switch if that switch requests ANI
before the DEFINITY ECS receives it from the originating switch. The
terminating switch may request ANI before the receipt of the last address digit if it
is not a DEFINITY ECS or it is a DEFINITY ECS with the Request Call Category
at Start of Call field set to
y.
Valid entries Usage
1
to 255 Enter the maximum number of seconds to elapse between signals
on a call. This timer runs when MFC tones are being sent or
received on an outgoing call. The timer starts (and restarts) when
the switch begins sending a forward signal and stops when the
switch receives the backward signal.
Valid entries Usage
11
to 255 Enter the maximum number of seconds to elapse between
forward signals on outgoing calls. The timer starts (and restarts)
when a forward tone is taken off the link and it stops when the
next forward tone is applied to the link.
Valid entries Usage
y
Send the group B signal for the intercept to the CO and play
intercept tone on the trunk.
n Use normal DID/TIE/ISDN intercept treatment.
Valid entries Usage
y/n
If y, DEFINITY ECS sends and receives digits one digit at a
time instead of enbloc. (With enbloc, digits are not sent until
the entire group of digits is received).