Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
1021Trunk Group
17
Field descriptions for page 4
This screen appears when the Direction field on Page 1 is
outgoing or two-way
and the ATMS field is
y on the Feature-Related System Parameters screen.
The figure below shows a common configuration for page 4 of the Trunk Group
screen when the Group Type field is
co. This screen is only an example, and the
fields shown below may change or disappear according to specific field settings.
Screen 213. CO Trunk Group ATMS Thresholds
!
CAUTION:
Customers: Do not change fields on this page without assistance from
Lucent Technologies or your network service provider.
50
The TN465B (or later) and TN2184 can only detect 12k and
16kHz PPM. Therefore, if
50 is administered, the circuit pack
will be set to detect 16kHz.
50/12k The TN465B (or later) and TN2184 can only detect 12k and
16kHz PPM. Therefore, if
50/12k is administered, the circuit
pack will be set to detect 12kHz.
50/16k
The TN465B (or later) and TN2184 can only detect 12k and
16kHz PPM. Therefore, if
50/16k is administered, the circuit
pack will be set to detect 16kHz.
Valid entries Usage
add trunk-group next Page 4 of x
ATMS THRESHOLDS
TTL Type: _________ Far End Test No: __________________
TTL Vendor: ______________ TTL Contact: ______________________
Trunk Vendor: ____________ Trunk Contact: ___________________
Trunk Length: _____
MARGINAL UNACCEPTABLE
Min Max Min Max
1004 Hz Loss: __ __ __ __
-Dev +Dev -Dev +Dev
404 Hz Loss: _ _ _ _
2804 Hz Loss: _ _ _ _
Maximum C Message Noise: __ __
Maximum C Notched Noise: __ __
Minimum SRL-HI: __ __
Minimum SRL-LO: __ __
Minimum ERL: __ __
Allow ATMS Busyout, Error Logging and Alarming? _
Maximum Percentage of Trunks Which Can Be Removed from Service by ATMS: __