Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
626Feature Access Code
17
Station Security Code Change Access Code
Enter the code the user must dial to change their Station Security Code. The SCC
must be administered before the user can change it using this FAC. That is, a user
cannot change a blank SCC.
Terminal Dial-Up Test Access Code
Used to perform tests on digital telephones to make sure that the telephone and the
buttons are communicating properly with the switch. See your Maintenance
documentation for information about Digital Terminal Remote Looparound Test.
Terminal Translation Initialization Merge Code
Enter the digits that must be dialed to install (merge) a station without losing any
of its previous feature settings. The Terminal Translation Initialization Separation
Code must have been used, or an X administered in the Port field of the Station
screen, when the telephone was removed from its former location in order for the
Terminal Translation Initialization Merge Code to be effective. (If you try to use
this and it doesn’t work, check the station screen for this extension. If there is still
a port assigned, type X in the port field, then try the TTI merge again.)
Terminal Translation Initialization Separation
Code
Enter the digits that must be dialed to remove (separate) a station from a location
without losing any of its feature settings.
Transfer to Voice Mail Access Code
Enter the digits that must be dialed to allow coverage to transfer the caller to the
original call recipient’s AUDIX mail where the caller can leave a message. Do not
administer this code to have the same first digit as another feature access code that
is longer in length.
Trunk Answer Any Station Access Code
Enter the access code that station users must dial to answer calls alerting on night
bells.
User Control Restrict Activation/Deactivation
Used to change the restriction level for a specific extension. Requires console
permissions.