Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
968Trunk Group
17
Field descriptions for page 1
The figure below shows a common configuration for page 1 of the Trunk Group
screen when the Group Type field is
tie. This screen is only an example, and the
fields shown below may change or disappear according to specific field settings.
Screen 210. Tie Trunk Group
Group Number
This field displays the group number assigned when the trunk group was added.
NOTE:
For trunk groups connecting 2 switches in Distributed Communication
System networks, Lucent recommends that you assign the same group
number on both switches.
add trunk-group next Page 1 of x
TRUNK GROUP
Group Number: ___ Group Type: ________ CDR Reports: _
Group Name: ___________________________ COR: __ TN: ___ TAC: ____
Direction: ________ Outgoing Display? _ Trunk Signaling Type: ____
Dial Access? _ Busy Threshold: ___ Night Service: _____
Queue Length: ___ Incoming Destination: _____
Comm Type: _____ Auth Code? _
Trunk Flash? _
BCC: _ ITC? ____
TRUNK PARAMETERS
Trunk Type (in/out): ____________ Incoming Rotary Timeout(sec): __
Outgoing Dial Type: _________ Incoming Dial Type: ________
Disconnect Timing(msec): ____
Digit Treatment: __________ Digits: ____
Sig Bit Inversion: none
Analog Loss Group: ___ Digital Loss Group: ___
Incoming Dial Tone? _
Bit Rate: _____ Synchronization: _____ Duplex: ____
Disconnect Supervision - In? _ Out? _
Answer Supervision Timeout: ___ Receive Answer Supervision? _