Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
About this document
xxConventions used in this document
■ Commands are printed in bold face as follows: command.
■ Keys and buttons are printed as follows: KEY.
■ Screen displays are printed in constant width as follows: screen
display
.
■ Variables are printed in italics as follows: variable.
■ We show complete commands in this book, but you can always use an
abbreviated version of the command. For example,
list configuration
station
can be entered as list config sta.
■ We show commands and screens from the newest DEFINITY system and
refer to the most current books. Please substitute the appropriate
commands for your system and refer to the manuals you have available.
■ If you need help constructing a command or completing a field entry,
remember to use
HELP.
■ When you press HELP at any point on the command line, a list of available
commands appears.
■ When you press HELP with your cursor in a field on a screen, a list of valid
entries for that field appears.
■ The status line or message line can be found near the bottom of your
monitor display. This is where the system displays messages for you.
Check the message line to see how the system responds to your input.
Write down the message if you need to call our helpline.
■ When a procedure requires you to press ENTER to save your changes, the
screen you were working on clears and the cursor returns to the command
prompt. The message line shows “
command successfully
completed
” to indicate that the system accepted your changes.
Tip:
Draws attention to information that you may find helpful.
NOTE:
Draws attention to information that you must heed.
!
CAUTION:
Denotes possible harm to software, possible loss of data, or possible service
interruptions.
!
WARNING:
Denotes possible harm to hardware or equipment.