Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Features and technical reference
1260Call Detail Recording
20
■ Date
You can include the date in customized records only. The format is based
on the value of the CDR Date Format field on the CDR System Parameters
form.
■ Dialed Number (dialed-num) — up to 23 digits
This field contains the number dialed. If it is an outgoing call, the field
contains the number dialed by a system user. If it is an incoming call, the
field contains the extension that was dialed (or implied, as in Dialed
Number Identification System). If more than 18 digits are dialed, the least
significant digits (starting from the right) are truncated.
If CDR Privacy is active for the calling number and this is an outgoing call,
the trailing digits of the dialed number are blank in the call record. If more
than 18 digits are dialed, the system truncates the dialed number to 18
digits, then blanks the administered number of digits.
For an outgoing (or originating) NCA-TSC or tandem NCA-TSC, this field
contains the dialed digits used to establish a route to a far-end switch. It
contains the extension of the local extension used as the NCA-TSC
endpoint when it is for a terminating NCA-TSC. For an unsuccessful
NCA-TSC, this field is blank.
The # sign (or E for some formats) may appear in this field in the following
cases for both ARS and TAC calls.
— When the user dials
# at the end of digit dialing
— If an outgoing call experiences an interdigit-timeout interaction with
the ARS Analysis table
— When a user dials a TAC for a Look Ahead Interflow (LAI). For
example: A successful LAI to <TAC> 1001 where 1001 is the
remote VDN extension will yield 1001E or 1001# in the Dialed
Number field. The # or E is used by the vector processing software
to indicate the end of dialing.
You can eliminate the # or E as the last digit of the CDR record using the
CDR System Parameters form.
■ Duration (duration or sec-dur) — 4 digits
This is the duration of the call, recorded in hours (0–9), minutes (00–59),
and to tenths of minutes (0–9). Calls are rounded down in 6-second
increments. Therefore, a call of 5-second duration will be indicated as 0
duration. If 9999 appears in this field, this call was in progress when a time
change was made in the switch.
You can use the customized record format to have the duration reported in
hours/minutes/seconds. This field is called sec_dur.