Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
576Data modules
17
Screen 66. Data Line Data Module — if KYBD Dialing is n
Refer to ‘‘DLC Option Settings’’ on page 580 for additional information when
assigning entries for the remaining fields on the screen.
KYBD Dialing
This option must be enabled to allow data endpoints to originate calls via the EIA
232C interface and obtain ASCII feedback text. When enabled, the user gets the
dial prompt. This option normally is enabled for “originate/receive” DTE that has
a need to set up data calls. If this option is disabled, originations cannot be done at
the DTE and text feedback does not occur at the DTE during call setup/take down.
Data call answering is still allowed but without text feedback.
NOTE:
ADU-type hunt groups connecting the system to terminal servers on a host
computer should have these hunt group extensions assigned as “no”
keyboard dialing.
Configuration
Appears when the KYBD Dialing field is
y. This option normally is enabled for
“originate/receive” DTE such as non-intelligent terminals and disabled for
intelligent devices such as computers. The KYBD Dialing field must be
y with
this option.
Valid entries Usage
y/n
Enter y to allow keyboard dialing. This enables the data
endpoint to receive and transmit text during call origination or
termination. Low must be
n.
Valid entries Usage
y/n
Enter y to allow the viewing and changing of options from the
DTE.
change data-module 30 DATA MODULE Page 2 of 2
CAPABILITIES
KYBD Dialing? n
Busy Out? n
SPEEDS
Low? y 1200? y 4800? y 19200? y
300? y 2400? y 9600? y
OPTIONS
Permit Mismatch? n