Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Collecting billing information
448Receiving call-charge information
16
2. In the CDR Reports field, type y.
This ensures that the PPM information appears on the CDR report.
3. In the Direction field, type
two-way.
4. In the PPM field, type y.
5. In the Frequency field, type
50/12.
This is the signal frequency (in kHz). The frequency you will use depends
on what the circuit pack you use is able to accept. See ‘‘
Trunk Group’’ on
page 967 for more information.
6. In the Administrable Timers section, set the Outgoing Glare Guard timer to
5 seconds.
7. Press
ENTER to save your changes.
8. You also need to ensure that the values of the Digital Metering Pulse
Minimum, Maximum and Value on the DS1 Circuit Pack screen are
appropriate to the values offered by your service provider. See ‘‘
DS1
Circuit Pack’’ on page 599 for more information.
Related topics
See ‘‘
Call Charge Information’’ on page 1195 for more information about AOC
and PPM.
Page 1 of x
TRUNK GROUP
Group Number: 3 Group Type: diod CDR Reports: y
Group Name: DIOD_PPM___________________ COR: 1_ TN: 1__ TAC: 112_
Direction: two-way_ Outgoing Display? n
Dial Access? n Busy Threshold: 99_ Night Service: ____
Queue Length: 0__
Comm Type: voice Auth Code? n Digit Absorption List:
Prefix-1? y Trunk Flash? n Toll Restricted? y
TRUNK PARAMETERS
Trunk Type: auto/immed
Outgoing Dial Type: tone Incoming Dial Type: tone
Trunk Termination: rc
Digit Treatment: Digits:
Expected Digits: Sig Bit Inversion: none
Trunk Gain: high Drop Treatment: silence
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0__ Recieve Answer Supervision: y