Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
872Route Pattern
17
BCIE (Bearer Capability Information Element)
Use BCIE to determine how to create the ITC codepoint in the setup message.
This field applies to ISDN trunks and appears if ITC is
both.
Service/Feature
Enter up to 15 characters to identify the Service/Feature carried by the
information element (IE) in a call in this route pattern. This field is required by
Call-by-Call Service Selection.
Service/Feature appears when ISDN-PRI or ISDN-BRI Trunks is
y on the
System-Parameters Customer-Options screen.
Band
Enter a number that represents the OUTWATS band number (US only).
WATS is a voice-grade service that provides both voice and low-speed data
transmission calls to defined areas (bands) for a flat rate charge.0
This field appears when the Services/Features field is
outwats-bnd and when
ISDN-PRI or ISDN-BRI Trunks field is
y on the System-Parameters
Customer-Options screen. Band is required by Call-by-Call Service Selection.
No. Dgts Subaddress
Allows a caller to reach a number where switch digit processing deletes the dialed
number and inserts the listed directory number (LDN). The LDN then is sent to
the destination address and the dialed extension is sent in the calling party
Valid entries Usage
ept
(endpoint)
unr (unrestricted)
Valid entries
accunet multiquest sdn
i800 operator sub-operator
inwats oper-lds (operator and lds) sub-op-lds
(sub-operator and lds)
lds oper-meg
(operator and megacon)
sub-op-meg
(sub-operator and megacom)
mega800 oper-sdn
(operator and sdn)
sub-op-sdn
(sub-operator and sdn)
megacom outwats-bnd wats-max-bnd