Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
System basics
14Saving translations
1
end of the specified grace period, otherwise you cannot access system
management commands (such as: add, change, remove, and duplicate) that
modify translation data. Lucent specifies the grace period during a system
installation or following an upgrade.
Before you start
If you are saving translations to a memory card or tape, you must verify the
memory card or tape is in place and clear any active alarms from the alarms panel.
If your switch is a G3csi or G3si, verify the memory card translation ID matches
the translation ID of your switch’s Flash PROM.
Instructions
In our example, we save translations to the tapes on both processor A and B.
To save translations manually:
1. Type
save translation both tape and press RETURN.
The save process can take up to 10 minutes. You cannot administer your
system while the save is in process. The Save Translation screen appears.
2. If there is an error message in the Command Completion Status field and
an error code in the Error Code field, clear the error and repeat the save
process.
More information
When mass storage system (MSS) devices on both processors in a duplex system
are specified, translation data is saved from the active processor to the active and
standby MSS devices at the same time. If the save to one device fails or one device
is out of service, the other save continues. You receive the status of each save
separately.
NOTE:
If you have a duplex system and you save translation data to both MSS
devices one at a time, translation data inconsistencies between the two
devices can occur.
SAVE TRANSLATION
Processor Command Completion Status Error Code
SPE_A Success 0
SPE_B Success 0