Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
System basics
2Logging into the system
1
Instructions
Logging into the system
This procedure provides instructions for logging in from the system terminal not a
remote terminal.
To log into the system:
1. Enter your login name and press
RETURN.
2. Enter your password and press
RETURN.
For security, your password does not display as you type it.
3. Enter the kind of terminal you have or the type your system emulates and
press
RETURN.
The Command prompt appears.
NOTE:
If you enter the wrong terminal type, it can lock up your system. If
the system is not responding to keyboard commands, type
newterm
and press RETURN. Enter the correct terminal type on the new screen
and press
RETURN. If this does not work, turn the power off only on
the terminal and then turn it back on. The terminal reboots and you
can login again.
Logging in for remote administration
To log in for remote administration:
1. Dial the Uniform Call Distribution (UCD) group extension number.
NOTE:
The UCD group extension number is assigned when you set up
remote administration.
■ If you are off-premises, use the Direct Inward Dialing (DID)
number, an Listed Directory Number (LDN) (you must use a
phone), or the trunk number dedicated to remote administration.
■ If you are on-premises, use an extension number.
If you dialed a DID number, dedicated trunk number, or extension,
you receive data tone or visually receive answer confirmation.