Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
489Attendant Console
17
DIRECT TRUNK GROUP SELECT BUTTON
ASSIGNMENTS (Trunk Access Codes)
Enter the trunk access codes (TACs) for local and remote switches. (There are
fields for one local TAC and one remote TAC per button labeled Local and
Remote.) The local TAC (1 to 4 digits) refers to a trunk group or Loudspeaker
Paging zone on this switch. Remote TACs are only useful in a private network
(including DCS) network. The remote TAC (1 to 3 digits) refers to a trunk group
on the remote switch. If a remote TAC is given, then the local TAC must refer to a
trunk group that connects directly to the remote switch and is also limited to 1 to 3
digits.
Lucent recommends a DCS trunk be specified as the local TAC between the local
and remote switches. If the TAC specified as local between the local and remote
switches is not a DCS trunk, the remote trunk cannot be monitored by the local
switch.
HUNDREDS SELECT BUTTON ASSIGNMENTS
Enter in the appropriate field (1 through 20), the hundreds group to be associated
with a Hundreds Group Select button located on an optional selector console.
Valid entries Usage
1-4 digit number
*
May be used as first digit
#
Valid entries Usage
1-3 digit hundreds
group (plus prefix, if
needed)
Fields 1 through 8 are used when the selector console is
a 24A-type console and fields 1 through 20 are used for
a 26A-type console. Enter a hundreds group number
that represents all but the last two digits of an extension
number (for example, the Hundreds Select Button
—
on the selector console
— for extension 3822 would be
“38”).