Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
732IP Trunk Configuration Manager
17
Dial/Routing Plan dialog box
The Dial/Routing Plan dialog box controls:
■ how the IP trunk application manipulates the digits it receives for outgoing
and incoming calls
■ the IP addresses to which outgoing calls are routed
■ the remote sites that can access the DEFINITY ECS application on your
switch
The Dial/Routing Plan dialog box contains the following parameters:
Parameter Description
ITS Servers Displays a list of the switches that you have designated as members
of the IP network.
Routing Info -
Originating Dial
Plan
■ Entry Type: Sets whether or not an outgoing call is accepted.
Valid values:
accept or reject. If you set this to reject, users
cannot make outgoing calls over the DEFINITY ECS
application.
■ Line Number: In non-DCS configurations, enter Any.
For DCS networks, specify the trunk group number for calls that
originate at this switch. The trunk group number must match the
trunk group number at the terminating switch.
■ Search Digits: Used for call routing. See the Dial/Routing Plan
Worksheets.
■ Replace Digits: Used for call routing. See the Dial/Routing Plan
Worksheets.
■ Destination Type: Sets the type of remote destination.
Valid entries:
ITS R1.0, ITS R1.2, and Netmeeting 2.1.
■ Destination IP: The IP address of the remote switch.
■ Port: Used to set the (remote destination) LAN port number. If
the Destination Type is ITS R1.0 or ITS R1.2, the default is 5000.
Do not change the default port number unless you are certain that
the remote destination has different port settings to accept calls.
Continued on next page