Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
829Multifrequency-Signaling-Related System Parameters
17
Forward Cycle Timer (sec)
This field appears only if Incoming Call Type is
mfe and Outgoing Call Type is
mfe or none.
Backward Cycle Timer (sec)
This field appears only if Incoming Call Type is
mfe and Outgoing Call Type is
mfe or none.
Incomplete Dial Timer (sec)
This field appears only if Incoming Call Type is
mfe and Outgoing Call Type is
mfe or none.
Outgoing Start Timer (sec)
The field appears only if Incoming Call Type and Outgoing Call Types are both
mfe.
Group II Called Party Category
Enter the type of group II signals that should be used on the outgoing R2-MFC
call
Valid entries Usage
1
to 255 Enter the number of seconds to wait to receive the check
frequency after sending an MFE signal. The switch drops the
call if the time runs out before it receives check frequency.
Valid entries Usage
1
to 255 Enter the number of seconds to wait to send the check frequency
after receiving an MFE signal.
Valid entries Usage
45
to 255 Enter the number of seconds to wait from the start of a call until
the end of the check frequency of the last signal. The switch
drops the call if the time runs out before it receives the check
frequency.
Valid entries Usage
1
to 255 Enter the number of seconds to time from seizure until the
beginning of the first Group A signal from the receiving end, and
from the end of the check frequency until the beginning receipt of
the first digit following the Group II signal.