Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
594Dial Plan Record
17
Local Node Number
Enter a number to identify a specific node in a switch network. This entry must
match the DCS switch node number and the CDR node number if they are
specified.
ETA Node Number
Enter the number of the destination switch for Extended Trunk Access (ETA)
calls. ETA calls are unrecognized numbers you can send to another switch for
analysis and routing. Such numbers can be Facility Access Codes, Trunk Access
Codes, or extensions that are not in the UDP table.
Uniform Dialing Plan
The Uniform Dialing Plan field must be y on the System-Parameters
Customer-Option screen before you can administer this field.
The Uniform Dialing Plan is a separate screen that must be administered if
4-digit
or
5-digit is entered in this field. The UDP provides a common 4- or 5-digit dial
plan that can be shared among a group of switches. Additionally, UDP can be used
alone to provide uniform 4- or 5-digit dialing between two or more private
switching systems without ETN, DCS, or Main/Satellite/Tributary configurations.
NOTE:
Local extensions of fewer digits can still be administered, but cannot be
reached from other switches.
!
CAUTION:
Caution: If you change the entry in the Uniform Dialing Plan field, all UDP
extension codes are lost.
Valid entries Usage
1
–63 Enter the number of a specific node in a network.
blank The field may be left blank if automatic restoration, DCS, and
CDR are not used.
Valid entries Usage
1
– 999 Enter the number of a destination switch.
Valid entries Usage
4-digit
Use a 4-digit Dial Plan.
5-digit
Use a 5-digit Dial Plan.
none
No Uniform Dialing Plan is administered.