Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
729IP Trunk Configuration Manager
17
Voice/Fax dialog box
Use the Voice/Fax property page to view information about, and configure some
of the capabilities of, the DSP subsystem.
The Voice/Fax property page contains the following parameters:
Time Out
1 to 600,000
Allows you to set the maximum time that can elapse with no
stimulus from the network before call will be disconnected with
reason of time-out.
Busy Tone Duration
(sec)
10 to 300
Allows you to set the maximum time that can elapse after a busy tone
is detected before call progress will be stopped.
Parameter Description
Enable Voice Voice transmission is enabled. Display-only information.
Enable Fax Enable or disable fax transmission.
Voice
■ Gateway Voice Coder: Sets the type of voice coder used for voice
calls. The voice coder type of both DEFINITY ECS systems
should agree, or voice quality may be poor or calls may not
connect.
■ Voice Frames per Packet: Sets the number of frames of voice
information sent in each packet when using the Gateway Voice
Coder.
Valid values:
1 (packet) or 2. Generally, 2 provides better voice
quality as long as packet loss is low.
■ H.323 Voice Coder: G732.1. Display only.
■ Voice Frames per Packet: Sets the number of frames of voice
information sent in each packet when using the H.323 Voice
Coder.
Valid values:
1 (packet) or 2. Generally, 2 provides better voice
quality as long as packet loss is low.
Continued on next page
Parameters Description
Continued on next page