Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Screen reference
633Feature-Related System Parameters
17
Self Station Display Enabled
Use this field to control the use of the
INSPECT button for digital display phones.
Self Station Display allows a user to display the primary extension associated with
a digital display phone. There are two methods: (1) enter a feature access code
(FAC), and (2) use the
INSPECT button. In either case, the display shows the
primary extension associated with the phone where the FAC or
NORMAL or EXIT
button is entered. In the case of the FAC, the display continues until a
display-altering event occurs (for instance, going on-hook or receiving an
incoming call). In the case of the
INSPECT button, the display continues until the
user presses the
NORMAL or EXIT button or until a display-altering event occurs.
Trunk-to-Trunk Transfer
Regulations in some countries control the settings for this field. See your Lucent
Technologies representative for assistance.
Automatic Callback — No Answer Timeout
Interval (rings)
Valid entries Usage
y
The primary extension does display when the INSPECT button is
pressed.
n The extension does not display when the INSPECT button is
pressed.
Valid entries Usage
all
Enter all to enable all trunk-to-trunk transfers. This allows
telephone users to set up trunk-to-trunk transfer, go on-hook
without disconnecting the call, and forward the call to a remote
location.
restricted
Enter restricted (restricted public) to restrict all public trunks
(CO, WATS, FX, CPE, DID, and DIOD).
none Enter none to restrict all trunks (except CAS and DCS) from
being transferred.
Valid entries Usage
2–9
. Enter the number of times the callback call rings at the calling
station before the callback call is canceled.