Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Managing trunks
341Adding a CO, FX, or WATS trunk group
12
Before you start
Before you can administer any trunk group, you must have one or more circuit
packs of the correct type with enough open ports to handle the number of trunks
you need to add. To find out what circuit packs you need, refer to the DEFINITY
ECS System Description.
Instructions
As an example, let’s set up a two-way CO trunk group that carries voice and
voice-grade data only. Incoming calls terminate to an attendant during business
hours and to a night service destination the rest of the time
To add the new CO trunk-group:
1. Type
add trunk-group next and press RETURN.
The Trunk Group
screen appears. The system assigns the next available
trunk group number to this group. In our example, we’re adding trunk
group 5.
2. In the Group Type field, type
co.
This field specifies the kind of trunk group you’re creating.
3. In the Group Name field, type
Outside calls.
This name will be displayed, along with the group number, for outgoing
calls if you set the Outgoing Display? field to y. You can type any name up
to 27 characters long in this field.
TRUNK GROUP
Group Number: 5 Group Type: co CDR Reports: y
Group Name: Outside calls COR: 85 TN: 1__ TAC: 105
Direction: two-way Outgoing Display? n
Dial Access? n Busy Threshold: 99 Night Service: 1234
Queue Length: 0 Country: 1 Incoming Destination: attd
Comm Type: voice Auth Code? n Digit Absorption List: _
Prefix-1? y Trunk Flash? n Toll Restricted? y
TRUNK PARAMETERS
Trunk Type: ground start
Outgoing Dial Type: tone Cut-Through? n
Trunk Termination: rc Disconnect Timing(msec): 500_
Auto Guard? n Call Still Held? n Sig Bit Inversion: none
Trunk Gain: high
Disconnect Supervision -In? y Out? n
Answer Supervision Timeout: 10 Receive Answer Supervision? n