Filter
Top Products
DEFINITY ECS Release 8.2
Administrator’s Guide
555-233-506
Issue 1
April 2000
Managing displays
110Displaying ICLID Information
6
Instructions
Let’s set up tie trunk group 10 to receive calling party information and display the
calling party number on the phone of the person called.
NOTE:
These instructions are for collecting ANI in the U.S. Refer to ‘‘Automatic
Number Identification’’ on page 1165 for information on ANI
administration outside the U.S.
1. Type
change trunk group 10.
The Trunk Group
screen for trunk group 10 appears.
2. Type
tone in the Incoming Dial Type field.
3. Press
NEXT PAGE and type *ANI*DNIS in the Incoming Tone (DTMF) ANI
field.
4. Press
ENTER to save your changes.
Displaying ICLID Information
Your switch collects the calling party name and number (Incoming Call Line
Identification, or ICLID) received from the central office (CO) on analog trunks.
TRUNK GROUP
Group Number: 10_ Group Type: tie_____ CDR Reports: r
Group Name: Node1 to Node3 _______ COR: 10 TN: ___ TAC: *10__
Direction: two-way Outgoing Display? n Trunk Signaling Type: ____
Dial Access? n Busy Threshold: 99_ Night Service: _____
Queue Length: ___ Incoming Destination: 2000_
Comm Type: voice Auth Code? n
Trunk Flash? n
BCC: _ ITC? ____
TRUNK PARAMETERS
Trunk Type (in/out): auto/auto-incorrect Incoming Rotary Timeout(sec): 5
Outgoing Dial Type: _________ Incoming Dial Type: tone
Disconnect Timing(msec): 500
Digit Treatment: __________ Digits: ____
Sig Bit Inversion: none
Incoming Dial Tone? y
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 0__ Receive Answer Supervision? y