Filter
Top Products
54-44
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 54 Configuring Routing Policies on Firewall Devices
Configuring RIP
Field Reference
Table 54-30 Setup Tab
Element Description
Networks Define one or more networks for RIP routing. Enter IP address(es), or
enter or Select the desired Network/Hosts objects (see Understanding
Networks/Hosts Objects, page 6-74); IP addresses must not contain any
subnet information. There is no limit to the number of networks you can
add to the security appliance configuration.
The RIP routing updates will be sent and received only through
interfaces on the specified networks. Also, if the network of an
interface is not specified, the interface will not be advertised in any RIP
updates.
Passive Interface Use this option to specify passive interfaces on the security appliance,
and by extension the active interfaces. The device listens for RIP
routing broadcasts on passive interfaces, using that information to
populate its routing tables, but does not broadcast routing updates on
passive interfaces. Interfaces that are not designated as passive, receive
and send updates. Choose one of these options:
1. None – No interfaces are designated as passive.
2. All Interfaces – All interfaces on the device are designated as
passive, except those entered the Excluded Interfaces field below.
3. Specified Interfaces – Only those interfaces explicitly specified in
the Interfaces field below are designated as passive.
Interfaces/Excluded
Interfaces
Use this field to specify the interfaces excluded from the passive list, or
those explicitly designated as passive, depending on your choice from
the Passive Interface list above:
• If you chose All Interfaces, this field is labeled Excluded
Interfaces: enter or Select only those interfaces to be excluded
(that is, those that are to be active not passive).
• If you chose Specified Interfaces in the Passive Interface list, enter
or Select those interfaces that are to be designated as passive.
Note You cannot specify two different RIP configurations for the
same interface.
RIP Version Choose the RIP versions for sending and receiving RIP updates:
• Receive Version 1 and 2, Send Version 1
• Send and Receive Version 1
• Send and Receive Version 2
Generate Default Route When selected, a default route is generated for distribution, based on
the Route Map you specify.
Route Map Specify the route map to use for generating default routes.
Note This field contains only the Route Map name. The Route Map
is created and contained within a FlexConfig; see Chapter 7,
“Managing FlexConfigs” for more information.