Filter
Top Products
60-53
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 60 Router Device Administration
VTY Policy Page
Password The password for accessing this VTY line.
The password is case sensitive and can contain up to 80 alphanumeric
characters. The first character cannot be a number. Spaces are not
allowed.
Enter the password again in the Confirm field.
Privilege Level The privilege level assigned to users on this VTY line. Valid values
range from 0 to 15:
• 0—Grants access to these commands only: disable, enable, exit,
help, and logout.
• 1—Enables nonprivileged access to the router (normal
EXEC-mode use privileges).
• 15—Enables privileged access to the router (traditional enable
privileges).
Note Levels 2-14 are not normally used in a default configuration,
but custom configurations can be created by moving commands
that are normally at level 15 to a lower level and commands that
are normally at level 1 to a higher level. You can configure the
privilege levels of commands using the CLI or by defining a
FlexConfig.
Note If you do not define a value, level 1 is assigned by default. This
value does not appear in the device configuration.
Disable all the EXEC
sessions to the router via this
line
When selected, EXEC sessions are disabled over this line. Select this
option when you want to allow only an outgoing connection on this
line. This option is useful for keeping a particular line free from
unsolicited incoming data that can tie up the line.
When deselected, EXEC sessions are enabled over this line. This is the
default.
Exec Timeout The amount of time (in seconds) that the EXEC command interpreter
waits to detect user input on the line. If no input is detected, the line is
disconnected. Valid values range from 0 to 2147483. The default is 600
(10 minutes). Setting the value to 0 disables the timeout.
Note Although the timeout is defined in seconds, it appears in the
CLI in the format [mm ss].
Table 60-22 VTY Line Dialog Box—Setup Tab (Continued)
Element Description