Filter
Top Products
65-50
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 65 Managing Cisco Catalyst Switches and Cisco 7600 Series Routers
IDSM Settings
• IDSM Slot-Port Selector Dialog Box, page 65-51
• Service Module Slot Selector Dialog Box, page 65-35
Field Reference
Create and Edit IDSM Data Port VLANs Dialog Boxes
Use the Create IDSM Data Port VLANs dialog box (or the Edit IDSM Data Port VLANs dialog box) to
define which traffic is directed to an IDSM data port and which sensing mode is used on that traffic.
Navigation Path
Go to the IDSM Settings Page, page 65-48, then click the Add or Edit button beneath the Data Port
VLANs table.
Related Topics
• Create and Edit IDSM EtherChannel VLANs Dialog Boxes, page 65-49
• IDSM Slot-Port Selector Dialog Box, page 65-51
• Service Module Slot Selector Dialog Box, page 65-35
Table 65-23 Create and Edit IDSM EtherChannel VLANs Dialog Boxes
Element Description
Channel Group The EtherChannel group to which the Ethernet interface is assigned.
Slot-Ports (Select button) Associates the chassis slot number (in which the relevant services
module is installed) with the data port in the format x -y, where x is the
slot number and y is the port number. For example, 2-1 refers to data
port 1 in slot 2.
Click Select to open the IDSM Slot-Port Selector Dialog Box,
page 65-51. From here, you can select the IDSM slot-port combinations
to include in the EtherChannel group.
Mode The running mode of the EtherChannel group:
• Capture (IDS)—The IDSM2 passively monitors network traffic
that was copied to its data ports by the Catalyst switch using either
VACL capture or SPAN.
• Trunk (IPS)—The IDSM2 operates as an 802.1Q trunk by
performing VLAN bridging between pairs of VLANs within the
same data port.
Capture Enabled Applies only when the running mode is Capture (IDS).
When selected, configures the specified channel group as a capture
destination. When deselected, the channel group does not act as a
capture destination.
VLAN IDs (Select button) Identifies which VLANs the specified channel group should allow.
Click Select to open the VLAN Selector Dialog Box, page 65-36. From
here, you can select VLANs to include or exclude.