Filter
Top Products
60-31
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 60 Router Device Administration
HTTP Policy Page
Step 8 (Optional) Create command authorization definitions for specific privilege levels:
a. Click the Add button under the Command Authorization Override table. The Command
Authorization Override dialog box is displayed. See Table 60-15 on page 60-34 for a description of
the fields in this dialog box.
b. Configure the command authorization definition as required.
c. Click OK. The dialog box closes and the authorization method is displayed in the Command
Authorization Override table.
d. Repeat a. through c. to create additional command authorization definitions.
HTTP Policy Page
Use the HTTP page to configure HTTP and HTTPS access on the router. You can configure HTTP
policies on a Cisco IOS router from the following tabs on the HTTP policy page:
• HTTP Page—Setup Tab, page 60-31
• HTTP Page—AAA Tab, page 60-32
For more information, see HTTP and HTTPS on Cisco IOS Routers, page 60-28.
Navigation Path
• (Device view) Select Platform > Device Admin > Device Access > HTTP from the Policy selector.
• (Policy view) Select Router Platform > Device Admin > Device Access > HTTP from the Policy
Type selector. Right-click HTTP to create a policy, or select an existing policy from the Shared
Policy selector.
HTTP Page—Setup Tab
Use the Setup tab of the HTTP page to enable HTTP and HTTP over Secure Socket Layer (HTTP over
SSL or HTTPS) on the router. You can optionally limit access to these protocols to the addresses defined
in an access control list.
Note As a general rule, Cisco IOS routers that have been discovered by Security Manager already have HTTPS
enabled because Security Manager uses SSL as the default protocol for communicating with them. See
Setting Up SSL on Cisco IOS Routers, page 2-4.
Navigation Path
Go to the HTTP Policy Page, page 60-31, then click the Setup tab.
Related Topics
• HTTP Page—AAA Tab, page 60-32
• HTTP and HTTPS on Cisco IOS Routers, page 60-28