Filter
Top Products
59-12
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 59 Configuring Router Interfaces
Router Interfaces Page
Interface Auto Name Generator Dialog Box
Use the Interface Auto Name Generator dialog box to have Security Manager generate a name for the
interface based on the interface type and its location in the router or switch.
Navigation Path
Go to the Create Router Interface Dialog Box, page 59-8, select Interface from the Type list, then click
Select in the Name field.
Field Reference
DLCI Applies only to serial subinterfaces with Frame Relay encapsulation.
Enter the data-link connection identifier to associate with the
subinterface. Valid values range from 16 to 1007.
Note Security Manager configures serial subinterfaces as
point-to-point not multipoint.
Description Additional information about the interface (up to 1024 characters).
Roles The interface roles assigned to this interface. A message is displayed if
no roles have yet been assigned.
Table 59-3 Create Router Interface Dialog Box (Continued)
Element Description
Table 59-4 Interface Auto Name Generator Dialog Box
Element Description
Type The type of interface. Your selection from this list forms the first part
of the generated name, as displayed in the Result field. For more
information, see Available Interface Types, page 59-2.
Card The card related to the interface.
Note When defining a BVI interface, enter the number of the
corresponding bridge group.
Slot The slot related to the interface.
Port The port related to the interface.
Note The information you enter in these fields forms the remainder
of the generated name, as displayed in the Result field.
Result The name generated by Security Manager from the information you
entered for the interface type and location. The name displayed in this
field is read-only.
Tip After closing this dialog box, you can edit the generated name
in the Create Router Interface dialog box, if required.