Filter
Top Products
59-52
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 59 Configuring Router Interfaces
PVCs on Cisco IOS Routers
Note Do not select an encapsulation type when defining the management PVC.
Note If you modify the virtual template settings on an existing PVC, you must enter the shutdown
command followed by the no shutdown command on the ATM subinterface to restart the
interface. This causes the newly configured parameters to take effect.
c. Select the Enable ILMI check box to enable the ILMI to manage this PVC. For more information,
see Understanding ILMI, page 59-49.
Note You cannot configure the management PVC on a subinterface.
d. Select the Inverse ARP check box to enable the PVC to dynamically learn the Layer 3 addresses that
are required to forward traffic to those devices.
Note Alternatively, you can create static address mappings, as described in Step 7.
e. In the PPPoE Max Sessions field, define the maximum number of PPPoE sessions allowed on the
PVC.
f. In the VPN Service Name field, define the static domain name to use for PPPoA sessions on the
PVC.
See Table 59-23 on page 59-57for a description of the fields on the Settings tab.
Step 6 (Optional) On the QoS tab of the PVC dialog box, define the type of ATM traffic shaping to perform on
the traffic carried by this PVC. Traffic shaping regulates the flow of traffic carried by the PVC by
queuing traffic that exceeds the defined bit rates. See Table 59-24 on page 59-61 for a description of the
fields on the QoS tab.
Step 7 (Optional) On the Protocol tab of the PVC dialog box, create static mappings for the IP addresses at the
other end of the PVC:
a. Click Add to display the Define Mapping dialog box. See Table 59-26 on page 59-65 for a
description of the fields in this dialog box.
b. Select IP Address, then enter the address or network/host object that you want to map, or click Select
to select a network/host object from a list or to create a new one.
c. Click OK. The static mapping is displayed on the Protocol tab.
d. Repeat a. through c. to define additional static mappings.
Note You can also use the Protocol tab to change the type of InARP to use, broadcast or
non-broadcast.
Step 8 Click Advanced to configure OAM management on the PVC. See Defining OAM Management on ATM
PVCs, page 59-53.
Step 9 Click OK to save your definitions locally on the client and close the dialog box. Your definitions are
displayed in the PVC table.