Filter
Top Products
59-36
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 59 Configuring Router Interfaces
ADSL Policy Page
The ADSL page is displayed. See Table 59-16 on page 59-37 for a description of the fields on this page.
Step 2 Click the Add button beneath the table to display the ADSL Settings dialog box. See Table 59-17 on
page 59-38 for a description of the fields in this dialog box.
Step 3 In the ATM Interface field, enter the name of the ATM interface or interface role on which you want to
define ADSL settings, or click Select to select an interface role or create a new one. For more
information, see Specifying Interfaces During Policy Definition, page 6-70.
Note The interface that you select must be physically present on the device; otherwise, deployment
fails.
Step 4 (Optional) Select the interface card type installed on the router.
Note When discovering from a live device, the correct interface card type is already displayed. If you
did not perform discovery on a live device, or if Security Manager cannot detect the type of
interface card installed on the device, this field displays “Unknown”.
Step 5 (Optional) When using IMA groups, select the Allow bandwidth change on ATM PVCs check box to
enable dynamic adjustments to VC bandwidth in response to changes in group bandwidth. If this check
box is left deselected, you must make these adjustments manually.
Step 6 (Optional) Specify the DSL operating mode for this ATM interface. See Table 59-14 on page 59-34 for
a list of the operating modes supported for each card type.
Step 7 (Optional) Select the Use low tone set check box to have the interface card use carrier tones 29 through
48.
Step 8 Click OK to save your definitions locally on the client and close the dialog box. Your definitions are
displayed in the ADSL table.
Note To edit an ADSL definition, select it from the table, then click Edit. To remove an ADSL
definition, select it, then click Delete.
Step 9 Repeat Step 2 through Step 8 to define ADSL settings on additional ATM interfaces. Only one ADSL
definition may be defined on an interface.
ADSL Policy Page
Use the ADSL page to create, edit, and delete ADSL definitions on the ATM interfaces of the router. For
more information, see Defining ADSL Settings, page 59-35.
Navigation Path
• (Device view) Select Interfaces > Settings > DSL > ADSL from the Policy selector.
• (Policy view) Select Router Interfaces > Settings > DSL > ADSL from the Policy Type selector.
Right-click ADSL to create a policy, or select an existing policy from the Shared Policy selector.