Cisco Systems CL-28826-01 Security Camera User Manual


  Open as PDF
of 2616
 
59-43
User Guide for Cisco Security Manager 4.4
OL-28826-01
Chapter 59 Configuring Router Interfaces
SHDSL Policy Page
Discovering Policies on Devices Already in Security Manager, page 5-15
Field Reference
Table 59-19 SHDSL Dialog Box
Element Description
Name The name of the controller. Enter a name manually, or click Select to
display a dialog box for generating a name. See Controller Auto Name
Generator Dialog Box, page 59-45.
Description Additional information about the controller (up to 80 characters).
Shutdown When selected, the DSL controller is in shutdown state. However, its
definition is not deleted.
When deselected, the DSL controller is enabled. This is the default.
Configure ATM mode When selected, sets the controller into ATM mode and creates an ATM
interface with the same ID as the controller. This is the default. You
must enable ATM mode and then perform rediscovery to configure
ATM or PVCs on the device.
When deselected, ATM mode is disabled. No ATM interface is created
on deployment.
Note You cannot remove ATM mode from a controller after it has
been saved in Security Manager.
Line Termination The line termination that is set for the router:
CPE—Customer premises equipment. This is the default.
CO—Central office.
DSL Mode The DSL operating mode, including regional operating parameters,
used by the controller:
[blank]—The operating mode is not defined. (When deployed, the
Annex A standard for North America is used.)
A—Supports Annex A of the G.991.2 standard for North America.
A-B—Supports Annex A or Annex B. Available only when the
Line Term is set to CPE. The appropriate mode is selected when the
line trains.
A-B-ANFP—Supports Annex A or Annex B-ANFP. Available only
when the Line Term is set to CPE. The appropriate mode is selected
when the line trains.
B—Supports Annex B of the G.991.2 standard for Europe.
B-ANFP—Supports Annex B-ANFP (Access Network Frequency
Plan).
Note The available DSL modes are dependent on the selected line
termination.
Line Mode settings